Vintage Windmill and Wind Generator Forum

Thanks Bob, I will work on it tomorrow after it sets in PB all night.
Regards Chester

I have removed the retaining nut for the fan shaft and had no issues. What I'm having problems with is removing the worm gear. I have been able to move it about 3/8 to 7/16 of and inch and then it stops. I think the key way is binding it up after it moves that 3/8 of and inch. I have been using heat ...

Bob, I'm going to try and tare down the WG today and see what parts I need for the head. Right now having trouble pulling the hub of the drive shaft. Thanks for the support.
Regards Chester

Thanks Bob, I will see if parts are available for it.
Regards Chester

Thank You for the response. I have been trying to get more photos upload on this issue. I'm trying again now to see if I can upload additional photos.

Additional pictures to support the ID of the windmill, could not get them on first posting.
Thanks Chester

Additional pictures to support the ID of the windmill, could not get them on first posting.
Thanks Chester

I was hoping that someone may be able to help identify the type of windmill head I have. The only marking on it are WAA1C1 which is on the side and on top of the head is" USE MEDIUM ZERO OIL" I have attached 3 photos, sorry I could not reduce the size of the photos any more than I have.