Stover Samson 6' ft. or 6.5 ft. windmill
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Thanks ,i was thinking same thing but thought someone might have a less drastic thought
-
PaulV
- Site Admin
- Posts: 1008
- Joined: Wed Dec 12, 2018 10:52 pm
- Location: Collinsville, Oklahoma
- Contact:
Re: Stover Samson 6' ft. or 6.5 ft. windmill
With my luck, I'd damage the case and other parts if I tried to straighten that. Easier to make a replacement pin than to repair a case, etc.
PaulV
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Where are you in Oklahoma?
Call Dan Benjamin for parts. P M me for the phone number.
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Are there any bearings in these or is it just oil lubed
Re: Stover Samson 6' ft. or 6.5 ft. windmill
I'm in tulsa Oklahoma area
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Mine had no bearings. Just steel shafts on cast. That is not unusual, but when things get rusty, it really locks up hard. If yours turns, then you have a great start.
Call Dan Benjamin for parts. P M me for the phone number.
Re: Stover Samson 6' ft. or 6.5 ft. windmill
I am less than 2 hours west of Paul.
Call Dan Benjamin for parts. P M me for the phone number.
Re: Stover Samson 6' ft. or 6.5 ft. windmill
You do not have the required permissions to view the files attached to this post.
Re: Stover Samson 6' ft. or 6.5 ft. windmill
On the picture where the broken cast is missing, I can not get my bearings on where it's located. Can you get another pic or 2 of that are? Thanks. I will go look at mine if I need to.
Call Dan Benjamin for parts. P M me for the phone number.
