Boss Vaneless

Generally speaking, this area is for general discussion about windmills, in most cases.
Post Reply
Kansas Rust Buzzard
Posts: 535
Joined: Fri Dec 28, 2018 9:33 pm

Boss Vaneless

Post by Kansas Rust Buzzard »

Can anyone give me the arm length or section board width (one with slots) I just have iron but I can figure it out but having a measurement to start with would sure help me out. Thanks
Terry
Posts: 222
Joined: Thu Dec 27, 2018 8:32 pm
Location: Moundridge Ks.

Re: Boss Vaneless

Post by Terry »

KRB

There is a Boss vainless at Shattuck inside the building. i do not have any measurements on it so I can not help you out.
Terry
Kansas Rust Buzzard
Posts: 535
Joined: Fri Dec 28, 2018 9:33 pm

Re: Boss Vaneless

Post by Kansas Rust Buzzard »

Thanks Terry, I may just have to wait for the windmill fair. I hope they delay it instead of cancelling it but I guess there is no telling. I have not been to Shattuck since they had a building with windmills, this is new to me.
Terry
Posts: 222
Joined: Thu Dec 27, 2018 8:32 pm
Location: Moundridge Ks.

Re: Boss Vaneless

Post by Terry »

The new building has been up 5+ years. you need to get down there and look at it.
Terry
Post Reply