factory fit

Well and cistern setup, repair, components (pumps, etc.), etc.
Post Reply
mtblah
Posts: 1624
Joined: Thu Mar 26, 2020 12:09 pm
Location: new braunfels TX

factory fit

Post by mtblah »

the jack shaft has a special notch & base clearance for the water pump.
John Deer cast the jack shaft but the V belt pully was cast by Case, it has the eagle & globe.
Now i need another project, a John Deere single cylinder motor to belt up to the jack shaft
I dont have enough projects yet, so motor is needed.
Mike B
New Braunfels TX
You do not have the required permissions to view the files attached to this post.
User avatar
windybob
Posts: 3503
Joined: Mon Jan 14, 2019 5:59 pm
Location: Ames Oklahoma

Re: factory fit

Post by windybob »

Great!
Call Dan Benjamin for parts. P M me for the phone number.
Wayne
Posts: 2115
Joined: Mon Dec 17, 2018 10:03 am
Location: Corsicana Tx.

Re: factory fit

Post by Wayne »

There are some JD engines listed in the classifieds of Smokstak.com. They are pricy like most John Deere stuff.
Next year if you could make the Portland Indiana show and I bet they would be some for sale there.
rockingjl
Posts: 232
Joined: Fri Dec 14, 2018 5:40 pm
Location: Phoenix Az

Re: factory fit

Post by rockingjl »

There is a guy here in the Phoenix that has several for sale right now, I can get a name & number for you. If you do want the number pm me and I get the info for you
User avatar
windybob
Posts: 3503
Joined: Mon Jan 14, 2019 5:59 pm
Location: Ames Oklahoma

Re: factory fit

Post by windybob »

Get ready for "cha-ching"
Call Dan Benjamin for parts. P M me for the phone number.
Post Reply