Heller Aller Mod 8

Share and discuss your windmill related projects.
Gregg
Posts: 257
Joined: Sat Dec 15, 2018 9:14 am
Location: Stratford, Iowa

Re: Heller Aller Mod 8

Post by Gregg »

I think Pat Hunt makes and sells "J-bolts" to hold them tight in the clips.
Gregg
Kenneth
Posts: 306
Joined: Fri Dec 28, 2018 11:03 am
Location: Tomball TX.

Re: Heller Aller Mod 8

Post by Kenneth »

Windy and Gregg,
I have already added the wheel clips from Pat Hunt.
I bought them when the Trade Fair was in Kendallville a few years back.
If i can find the picture i will post it.

Kenneth
sshosier
Posts: 9
Joined: Thu Apr 09, 2020 8:56 am
Location: Pendleton, IN

Re: Heller Aller Mod 8

Post by sshosier »

Gregg wrote: Sun Jun 07, 2020 9:47 pm I think Pat Hunt makes and sells "J-bolts" to hold them tight in the clips.
Gregg
Do you have a picture of these? I just put up my Heller Aller and it seems to have a some rattling of the blades (not sure if anything more than normal). Wondering if I should have secured them better. It just had the regular clips with a crimped edge and a screw placed at the bottom inside the center ring to keep them from sliding out.
Gregg
Posts: 257
Joined: Sat Dec 15, 2018 9:14 am
Location: Stratford, Iowa

Re: Heller Aller Mod 8

Post by Gregg »

Here are a couple of pictures of Pat Hunts wheel clips & J-bolts. The J-bolt hooks in the extra hole Pat has in the clip and the bolt would pass thru a hole in the blade with the nut keeping it tight to the clip.
Gregg
20200703_104155 (3).jpg
20200703_104414 (3).jpg
You do not have the required permissions to view the files attached to this post.
Post Reply