Baker WB & three leg tower issue

Share and discuss your windmill related projects.
User avatar
windybob
Posts: 3508
Joined: Mon Jan 14, 2019 5:59 pm
Location: Ames Oklahoma

Re: Baker WB & three leg tower issue

Post by windybob »

No Wayne, that's a figment of your imagination. All the trees and branches down here are a figment of mine. lol
Call Dan Benjamin for parts. P M me for the phone number.
Wayne
Posts: 2115
Joined: Mon Dec 17, 2018 10:03 am
Location: Corsicana Tx.

Re: Baker WB & three leg tower issue

Post by Wayne »

Yeah Windy that's the problem with having so much time on my hands my imagination runs wild.
Smax
Posts: 458
Joined: Thu Jan 03, 2019 12:06 pm
Location: Ardmore,oklahoma
Contact:

Re: Baker WB & three leg tower issue

Post by Smax »

Jim I have a three leg wb baker if you still need measurements I have been offline and just now seen your post
User avatar
Jim Corcoran
Posts: 291
Joined: Fri Dec 21, 2018 7:32 am
Location: Austin, Texas

Re: Baker WB & three leg tower issue

Post by Jim Corcoran »

Steve,
Thanks for the offer. I have a solution. I have a design of a 1/2" thick plate that can be used as an adapter between the WB lower ball race (head plate) and the the tower plates for the Stover 3 leg tower. I just need to get the plate cut and figure out where to drill all the holes and I should be home free.
Thanks once again.
Jim
" You need to get at least 30 miles out of Austin before you're firmly back in Texas."
CTXmiller
Posts: 933
Joined: Sat Dec 15, 2018 12:01 pm
Location: Waco, TX

Re: Baker WB & three leg tower issue

Post by CTXmiller »

I had posted this adapter plate for thoughts at some point in the past. It went to a Stover best I can tell as it came with a Stover turn table and M or a S.
You do not have the required permissions to view the files attached to this post.
Post Reply