Page 1 of 1

Turntable bearing

Posted: Mon Mar 01, 2021 10:05 pm
by Mike Hage
Any ideas on a turntable bearing for 6 and 32v winchargers?

Re: Turntable bearing

Posted: Fri Mar 12, 2021 7:57 pm
by Wind Charger Mike
The original thrust bearing used on the 6v and smaller 32v machines was a NICE 5464. I’ve not been able to find them. You could machine a couple flat washers, surface grind or sand flat...add some grease will work in a pinch. Otherwise Torque Transmission TB-125 works if you open up the ID a little. Amazon shows then to be in stock.