Does anyone have pics and/or measurements of a post mount for an 8' mill (any model)?
I saw a couple pics of a Star 12 with post mounts and decided I want to do that with mine. I thought I might be getting the original mounts ... but it doesn't look like that will be the case. So, I think I will make something up ... either fab it or draw it up in CAD, print it in plastic and have it cast (or maybe put my big boy panties on and finally do my own iron pour).
Post mount??
Post mount??
Thanks,
Ed
Ed
Re: Post mount??
There is a post mount at the center in Lubbock. Might check their site for photos. It sets outside.
Re: Post mount??
Ed is this what you're looking for ???
You do not have the required permissions to view the files attached to this post.
Re: Post mount??
Ivan, yes. That one as a bit different (post on each side) vs the one I have seen pics of.
Wayne, thanks I will look around their website.
Here are the only two pics that I have. I'm not sure why I didn't post the pics earlier!
Wayne, thanks I will look around their website.
Here are the only two pics that I have. I'm not sure why I didn't post the pics earlier!
You do not have the required permissions to view the files attached to this post.
Thanks,
Ed
Ed
-
Windcatcher530 Dan
- Posts: 2220
- Joined: Sun Mar 28, 2021 4:06 pm
- Location: Alcove N.Y.i buy and restore
Re: Post mount??
Ed would it be possible to fab a steel bracket that wrapped around and bolted to the bed plate with a flat side to bolt to the post and the same with the truing spider?
