Aermotor M1 Grinder parts

Need something? Post your request here.
hwy8
Posts: 217
Joined: Sun Feb 10, 2019 7:49 am
Location: Stillwater, MN

Re: Aermotor M1 Grinder parts

Post by hwy8 »

Do you still have the slip clutch? Is it a regular pulley with a clutch built into it? I'm dreaming of making a line shaft set up so I'd better get started looking at some old millwright books just to become acquainted with the mechanisms and all of the parts.
Windcatcher530 Dan
Posts: 1902
Joined: Sun Mar 28, 2021 4:06 pm
Location: Alcove N.Y.i buy and restore

Re: Aermotor M1 Grinder parts

Post by Windcatcher530 Dan »

When I sold the power mill all parts went with it. Here's what the slip or ratchet clutch and foot gear look like.
20220704_103833.jpg
20220704_103833.jpg
You do not have the required permissions to view the files attached to this post.
Windcatcher530 Dan
Posts: 1902
Joined: Sun Mar 28, 2021 4:06 pm
Location: Alcove N.Y.i buy and restore

Re: Aermotor M1 Grinder parts

Post by Windcatcher530 Dan »

20220704_103848.jpg
You do not have the required permissions to view the files attached to this post.
hwy8
Posts: 217
Joined: Sun Feb 10, 2019 7:49 am
Location: Stillwater, MN

Re: Aermotor M1 Grinder parts

Post by hwy8 »

I didn't have a clue that is what a "slip clutch" is....I was thinking it is a belt-pulley with a clutch to engage/disengage....
Windcatcher530 Dan
Posts: 1902
Joined: Sun Mar 28, 2021 4:06 pm
Location: Alcove N.Y.i buy and restore

Re: Aermotor M1 Grinder parts

Post by Windcatcher530 Dan »

Burt if you have any further questions you can give me a call at 518-948-3299 (Dan)
Post Reply