Hi, I have a 1978 or so Wincharger 200watt 12volt. The voltage regulator device bolted to tail section was smashed. Was wondering about using a 10A solar controller in place of the destroyed transistorized unit. Does the pos. go to controller first ? only 2 terminals on slip ring. Id like to have a picture of the intact device on a working Wincharger like mine.
Thanks, Ed
winco 12 v wincharger manuel
-
EarthQuaker
- Posts: 14
- Joined: Sat Feb 19, 2022 4:21 pm
- Location: Terrebonne OR 97760
-
Wind Charger Mike
- Posts: 289
- Joined: Sat Feb 09, 2019 12:42 pm
- Location: Manor, Texas
- Contact:
Re: winco 12 v wincharger manuel
The attached diagram might help you
You do not have the required permissions to view the files attached to this post.
-
EarthQuaker
- Posts: 14
- Joined: Sat Feb 19, 2022 4:21 pm
- Location: Terrebonne OR 97760
Re: winco 12 v wincharger manuel
Hi, thanks, I got message: didn't have the required documents to scan pdf"Wind Charger Mike wrote: Thu Feb 16, 2023 6:39 pm Scanned Document 6.pdfThe attached diagram might help you
-
EarthQuaker
- Posts: 14
- Joined: Sat Feb 19, 2022 4:21 pm
- Location: Terrebonne OR 97760
Re: winco 12 v wincharger manuel
Ooops ....required perrmission?Wind Charger Mike wrote: Thu Feb 16, 2023 6:39 pm Scanned Document 6.pdfThe attached diagram might help you
-
EarthQuaker
- Posts: 14
- Joined: Sat Feb 19, 2022 4:21 pm
- Location: Terrebonne OR 97760
Re: winco 12 v wincharger manuel
Wincharger :Model W02HS4D-212H/A
Ser 75175 U 83
Volts 12
watts 200
Mian question:What is the transistorized unit? Did it turn the circuit on / off based on wind speed? I built a wind machine in 1981 that had a small wind vane hooked to a momentary switch that turned the alternator on when it hit 7 mph. My question is if I can abandon the 12 gauge multi-strand wire hooked to broken transistorized/ capacitor device all together? I would use a solar controller 20amp or so...? Im assuming there is no replacement part for this wincharger unit.
Ser 75175 U 83
Volts 12
watts 200
Mian question:What is the transistorized unit? Did it turn the circuit on / off based on wind speed? I built a wind machine in 1981 that had a small wind vane hooked to a momentary switch that turned the alternator on when it hit 7 mph. My question is if I can abandon the 12 gauge multi-strand wire hooked to broken transistorized/ capacitor device all together? I would use a solar controller 20amp or so...? Im assuming there is no replacement part for this wincharger unit.
You do not have the required permissions to view the files attached to this post.
