A windmill I just took down. What brand s it?

mtblah · Post by **mtblah** » Wed Jan 03, 2024 5:50 pm

Michael , under what section did you see those for sale ?
looks like good "stuff " & close to me

CTXmiller · Post by **CTXmiller** » Wed Jan 03, 2024 6:14 pm

mtblah wrote: ↑Wed Jan 03, 2024 5:50 pm Michael , under what section did you see those for sale ?
looks like good "stuff " & close to me

Facebook MarketPlace. Looks a little pricy…upon reading the ad in more detail.

mtblah · Post by **mtblah** » Wed Jan 03, 2024 7:01 pm

Your right , not close enough on price to even bother to negotiate , way o far apart on $

randallbostick · Post by **randallbostick** » Sat Jan 06, 2024 9:21 pm

I’ll check it out. The tailbone does look like a match.

randallbostick · Post by **randallbostick** » Sat Jan 06, 2024 10:33 pm

Does anyone happen to have a parts diagram or exploded view of the Model 45? It appears that 8ft and 10ft use many of the same parts.

windybob · Post by **windybob** » Sun Jan 07, 2024 11:53 am

see if this works....

Fairbanks Morse Model 45 Parts List.pdf

randallbostick · Post by **randallbostick** » Sun Jan 07, 2024 2:40 pm

Awesome Windybob. Thank you so much.

mtblah · Post by **mtblah** » Sun Jan 07, 2024 6:34 pm

main shaft bearing set up is similr to the Dempster #12

randallbostick · Post by **randallbostick** » Wed Jan 10, 2024 7:37 am

Anyone have a lead on where I can find a section of the blades for a 10 foot head?

Vintage Windmill and Wind Generator Forum