HELLO
DOES ANYONE HAVE A SET OF 4 " GIRTS" [BRACES] FOR A SAMSON MODEL S UPPER TOWER LIKE THE ONES IN THE ATTACHED PICS ? THANK YOU , MIKE IN ARIZONA
8 FT. SAMSON MODEL S TOWER GIRTS
8 FT. SAMSON MODEL S TOWER GIRTS
You do not have the required permissions to view the files attached to this post.
Re: 8 FT. SAMSON MODEL S TOWER GIRTS
Is that 4 inches center-to-center for the holes?
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: 8 FT. SAMSON MODEL S TOWER GIRTS
hi bob
I PUT THE WORD " GIRTS " IN PARENTHESIS BECAUSE I WASN'T SURE I WAS USING THE RIGHT DESCRIPTION FOR THESE THINGS . MY UPPER TOWER WAS SO BENT UP I CAN'T TELL WHAT THE MEASUREMENT IS . IT COULD BE 6 INCHES FROM CENTER , BUT I'M NOT SURE AT THIS POINT . I DON'T KNOW WHY THE UPPER GIRTS ARE MISSING FOR MY UPPER TOWER . I DO THINK IT IS A SAMSON TOWER . IT HAD WOOD POLES BETWEEN THE UPPER & LOWER LEGS . IT WAS HALF WOOD & HALF ANGLE IRON . MIKE
I PUT THE WORD " GIRTS " IN PARENTHESIS BECAUSE I WASN'T SURE I WAS USING THE RIGHT DESCRIPTION FOR THESE THINGS . MY UPPER TOWER WAS SO BENT UP I CAN'T TELL WHAT THE MEASUREMENT IS . IT COULD BE 6 INCHES FROM CENTER , BUT I'M NOT SURE AT THIS POINT . I DON'T KNOW WHY THE UPPER GIRTS ARE MISSING FOR MY UPPER TOWER . I DO THINK IT IS A SAMSON TOWER . IT HAD WOOD POLES BETWEEN THE UPPER & LOWER LEGS . IT WAS HALF WOOD & HALF ANGLE IRON . MIKE
-
Windcatcher530 Dan
- Posts: 2157
- Joined: Sun Mar 28, 2021 4:06 pm
- Location: Alcove N.Y.i buy and restore
Re: 8 FT. SAMSON MODEL S TOWER GIRTS
I'll try to take measurements on my Stover tower tomorrow and some pics !!!
-
Windcatcher530 Dan
- Posts: 2157
- Joined: Sun Mar 28, 2021 4:06 pm
- Location: Alcove N.Y.i buy and restore
Re: 8 FT. SAMSON MODEL S TOWER GIRTS
Bolt hole center top gurt 5 3/4 , next gurt down 11 1/4 bolt holes. Gurts are 27inches apart.
You do not have the required permissions to view the files attached to this post.
