Thankyou for the measures. The place to buy steel is 30 miles away . I will be there in a month for dentist so will pick it up then. Still 6 bikes in the shop to fix and move out.
I noticed the mount is offset at front. Is that on purpose?
jerry
new in Canada
-
Peter vk
- Posts: 344
- Joined: Sat Dec 15, 2018 11:30 am
- Location: Chesterville Ontario Canada
- Contact:
Re: new in Canada
Yes the front mount is offset by 1 inch.
You do not have the required permissions to view the files attached to this post.
Re: new in Canada
Thankyou
Re: new in Canada
Hello all,
Have a little time. Here is a pic of my Beatty pivot for the tailbone. The matching piece is held together by a bolt with a flat edge.
Where would I get one?
Thanks
jerry
Have a little time. Here is a pic of my Beatty pivot for the tailbone. The matching piece is held together by a bolt with a flat edge.
Where would I get one?
Thanks
jerry
You do not have the required permissions to view the files attached to this post.
-
Peter vk
- Posts: 344
- Joined: Sat Dec 15, 2018 11:30 am
- Location: Chesterville Ontario Canada
- Contact:
Re: new in Canada
3/8 carriage bolt, you can get them at the hardware stores
Re: new in Canada
Curious about why the flat edge. Mistake in casting?
