ID tower
Re: ID tower
Had a e-mail from Issiaih Yott of the Kregel windmill factory museum he thought it looks as if it could be a ELI Tower. Any thoughts?
Thanks
You do not have the required permissions to view the files attached to this post.
Re: ID tower
I saw that it could possibly maybe be an Eli. I had that on the short list.
The picture of the splice right above this post looks home made from what I can see. Not like any other I have run across. On the previous page (2) the splice, I will check what I have. I have both Dempster and Stover.
That flat steel strap step in the above picture I don't recognize. Sure would be hard on the feet.
t.hoop, you are 1 -1/2 hrs away from me.
The picture of the splice right above this post looks home made from what I can see. Not like any other I have run across. On the previous page (2) the splice, I will check what I have. I have both Dempster and Stover.
That flat steel strap step in the above picture I don't recognize. Sure would be hard on the feet.
t.hoop, you are 1 -1/2 hrs away from me.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: ID tower
Yes, the flat steel step would be hard on the feet but men were men back then,with hard boots! lol
Thanks again to everyone for the help.
Thanks again to everyone for the help.
Re: ID tower
This could be a Fairbanks-Morse tower. I bought a similar tower from WB several years ago, so it’s likely this is what your tower is. It also has the same type of wire tension bolts that go through the grits. Ladder also is similar. The tower top on my WG had the flat plates riveted. Your tower looks like it may have had an early dempster tower cap adapted.
Lance
Lance
Re: ID tower
I have a 3 legged tower with the twist wire and the flat step ladder. I'll have to go check it out today.
Re: ID tower
Thanks Lance. I knew I'd seen those tensioners before somewhere.
Did'nt get a look at the tie-wire splice yet. Going to dr for a bit of surgery.
Did'nt get a look at the tie-wire splice yet. Going to dr for a bit of surgery.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: ID tower
Thanks for all the input
Re: ID tower
Good luck Windy!
Re: ID tower
Dang! I forgot to check today. Lots going on lately. Sorry. will try in the morning.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: ID tower
Ok here is an original Dempster wire splice. Now we have one tower covered.
You do not have the required permissions to view the files attached to this post.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.