after pouring the A702 babbitt bearings i immediately started assembly !
the case even got a little red paint.
i constructed a tripod to hold the motor upright for assmbly as the 3 legged tower will eventually hold the motor in the air.
now twisitng the wire for the upper section of the tower.
Thank you windybob, Paul V for the encouragement to under take this kind of project.
Mike Blahnik
New Braunfels TX
some assembly required
some assembly required
You do not have the required permissions to view the files attached to this post.
Re: some assembly required
Looking Good!
Re: some assembly required
Why did you pour bearings into a 702?
Re: some assembly required
Bryon,
both pitman arm's # 686 bearing , large gear bearing # 752 carrier bearing
both pitman arm's # 686 bearing , large gear bearing # 752 carrier bearing
Re: some assembly required
You did the snout bearing?? Really? That one is tricky. There is one right way and too many wrong ways for that one.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: some assembly required
Got it.
