Aermotor D602
-
- Posts: 3
- Joined: Wed Sep 16, 2020 11:04 am
- Location: Show Low AZ
Aermotor D602
I'm getting confused on which wheel spoke goes in which hole on the outside ring. Cant find any good clear pictures of a 602. Can anyone set me straight?
Re: Aermotor D602
Same as a 702. Same pattern for all. Spokes should CROSS in the middle after coming out of the hub.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: Aermotor D602
There are pictures somewhere on the site.....maybe check the library under Aermotor.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: Aermotor D602
Oh,..Welcome to the site!
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: Aermotor D602
Each outer band has 2 holes, one for a spoke from front of hub and one for spoke from rear. As you start putting on sections, keep overlapping them the same way all the way around the wheel. When you get to the last one, you will need to drop off one side of the first section to get the overlap right.
Hard to explain it that it will make sense. Bryon has a nice colored diagram, but I cannot find it.
Also make sure the angle of the threaded part of the V-spoke are angled to the outside when installing on the hub. That way the threads (tips of spokes) will be on the center line of the wheel.
Hard to explain it that it will make sense. Bryon has a nice colored diagram, but I cannot find it.
Also make sure the angle of the threaded part of the V-spoke are angled to the outside when installing on the hub. That way the threads (tips of spokes) will be on the center line of the wheel.
Last edited by Mister Ed on Thu Oct 22, 2020 11:37 am, edited 1 time in total.
Thanks,
Ed
Ed
-
- Posts: 3
- Joined: Wed Sep 16, 2020 11:04 am
- Location: Show Low AZ
Re: Aermotor D602
I have the spokes on the right way. I will start putting the sails on this weekend. I will start with a front spoke then a rear spoke all the way around. Thank you to all for the replys.
Re: Aermotor D602
This is the same pattern for the screw-in spokes too.
You do not have the required permissions to view the files attached to this post.
-
- Posts: 3
- Joined: Wed Sep 16, 2020 11:04 am
- Location: Show Low AZ
Re: Aermotor D602
Byron - thank you very much. That is exactly what I needed.
Paul
Paul