Dempster 14

[Mike Hage]

20210530_131740.jpg

I put this mill together today. Does anyone have any ideas on getting started building the fan sections? What type of wood. Where can I find dimensions? It's in rough shape, got used a little for target practice but I've got a line on some parts ones. Thank you Windy for the info on the pullout tube got it all cleaned up and got it sort of working. There is a lot of mechanism to overcome to pull it in

[Wayne]

I'd wonder if the wheel sections would be the same as a 3 and 4.

[Terry]

Yes
the wheel sections for the 14 are the same as the 3 or 4.
I have been working on a # 14
Terry

[Mike Hage]

Where can I find dimensions for the wood?

[Terry]

I could get.you some dimension's for that.
It will be next week before I can get them.
Terry

[Mike Hage]

Thank you that would be wonderful

[Terry]

I will get them measured.
Terry

[Terry]

Mike
I sent you a PM
Terry

[joe herman]

Hi Terry,
Guess I will also need those dimensions when its comes time for me to work
on my Dempster #14.
Hope we will get the castings by fair time.
Joe

[Mike Hage]

Thank you Terry. I'll likely have a few questions for you once I get into it. I'll have to gather up some sticks first. What type of wood are we looking at? I'll share this with Joe too