Re: How do I drill a hole into the corner of angle iron?
Posted: Fri May 14, 2021 8:10 pm
Vintage Windmill and Wind Generator Forum
Est. Dec. 13, 2018
https://vintagewindmillforum.com/
How do I drill a hole into the corner of angle iron?
Page 2 of 2
Re: How do I drill a hole into the corner of angle iron?
Posted: Sun May 16, 2021 11:19 pm
Today, I was taking apart a mast pipe in a home-made stub tower and this spacer fell out: It looks like about a hundred years ago, somebody was using the same method Windy was suggesting.
Re: How do I drill a hole into the corner of angle iron?
Posted: Mon May 17, 2021 4:51 am
Might have been Windy
Re: How do I drill a hole into the corner of angle iron?
Posted: Mon May 17, 2021 8:28 am
I do feel that old half the time. My last uncle passed last week. He was just short of 102. No way I make that!
Re: How do I drill a hole into the corner of angle iron?
Posted: Tue May 18, 2021 5:23 pm
I drill a small hole fromt he inside out, then grind a flat spot on the point and drill outside in if I am in the field. If I am in the shop I clamp it in the Bridgeport and use an endmill, easy peasy.