Vintage Windmill and Wind Generator Forum

Thanks Dave and Windy,

Can anybody privide the correct pic of stem pipe and pull out tube and how it works. Mine is old and not sure it will work. Thanks.

I make neckpipes and pullouts all the time. I would need to be at the shop for measurements..

JBarker wrote: Sun Jan 27, 2019 8:50 pm Windybob....where do u get felt?

JBaker I saw felt earlier on windmill-parts.com on their EBAY page.

Rhettro wrote: Mon Feb 04, 2019 12:26 pm

JBarker wrote: Sun Jan 27, 2019 8:50 pm Windybob....where do u get felt?

JBaker I saw felt earlier on windmill-parts.com on their EBAY page.

Thank you for the tip.

Jerry

Rhettro wrote: Mon Feb 04, 2019 12:26 pm

JBarker wrote: Sun Jan 27, 2019 8:50 pm Windybob....where do u get felt?

JBaker I saw felt earlier on windmill-parts.com on their EBAY page.

I noticed they sell O-ring for snout spacer and the felt washer. I don't remember having an O-ring for snout spacer on my 01201N Dempster when I took apart. Where does it go? Thanks

Jerry

Jerry , the snoot spacer o-ring would be for the later model #12A. Looks like yours is a #12 which doesnt require that.

JBarker wrote: Sun Jan 27, 2019 8:50 pm Windybob....where do u get felt?

Somewhere between my head and toes but I'm not gonna say. It's personal. hahahaha

windybob wrote: Mon Feb 04, 2019 6:03 pm

JBarker wrote: Sun Jan 27, 2019 8:50 pm Windybob....where do u get felt?

Somewhere between my head and toes but I'm not gonna say. It's personal. hahahaha

lol

What is the correct sequence to reassembling the main shaft? Is the first part the spiral oil chaser then the spring and then front bearing? If so, how do you compress the spring and hold in place to get the steal washer in place? Hope these arent stupid questions....
Thanks for all the help.

Jerry