Page 2 of 2
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Posted: Fri Aug 27, 2021 3:20 pm
by Russail
Thanks ,i was thinking same thing but thought someone might have a less drastic thought
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Posted: Fri Aug 27, 2021 3:25 pm
by PaulV
With my luck, I'd damage the case and other parts if I tried to straighten that. Easier to make a replacement pin than to repair a case, etc.
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Posted: Fri Aug 27, 2021 5:27 pm
by windybob
Where are you in Oklahoma?
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Posted: Fri Aug 27, 2021 5:55 pm
by Russail
Are there any bearings in these or is it just oil lubed
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Posted: Fri Aug 27, 2021 5:57 pm
by Russail
I'm in tulsa Oklahoma area
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Posted: Fri Aug 27, 2021 9:43 pm
by PaulV
Russell, I am in the Tulsa area. Sending you PM.
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Posted: Sat Aug 28, 2021 8:55 am
by windybob
Mine had no bearings. Just steel shafts on cast. That is not unusual, but when things get rusty, it really locks up hard. If yours turns, then you have a great start.
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Posted: Sat Aug 28, 2021 8:55 am
by windybob
I am less than 2 hours west of Paul.
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Posted: Mon Aug 30, 2021 12:01 pm
by Russail
Re: Stover Samson 6' ft. or 6.5 ft. windmill
Posted: Mon Aug 30, 2021 3:28 pm
by windybob
On the picture where the broken cast is missing, I can not get my bearings on where it's located. Can you get another pic or 2 of that are? Thanks. I will go look at mine if I need to.