Page 2 of 2
Re: Wooden Sucker rod end
Posted: Wed Dec 22, 2021 9:09 am
by mtblah
ignore the 1st double exposure miss print
Re: Wooden Sucker rod end
Posted: Wed Dec 22, 2021 10:18 am
by Jim Corcoran
Wayne,
If this is what you need, it's yours.
20211222_100806.jpg
Regards,
Jim
Re: Wooden Sucker rod end
Posted: Wed Dec 22, 2021 1:00 pm
by windybob
There ya go Wayne. A set. That's more than I have.
Re: Wooden Sucker rod end
Posted: Thu Dec 23, 2021 8:46 am
by Wayne
Yeah Man! I sent you a PM Jim.
Re: Wooden Sucker rod end
Posted: Fri Dec 24, 2021 9:19 am
by Wayne
Wow! You do have some sucker. The best I can figure mine is will only need to be about 12=14 ft long. I'll have to size it after I get the tower up and pump set in place. Are those rods 1 1/4 inch square? My Dandy tower has the rod guide in it and the square hole is a little bigger than 1 1/4 inch.
Re: Wooden Sucker rod end
Posted: Fri Dec 24, 2021 11:46 am
by mtblah
Round , 1 1/8 dia + or - these were trees so there is some veriance
14 ft 4 inches long measured from end of fitting to opposite end of fitting .
+ or - an inchch or so .
Mike B
Re: Wooden Sucker rod end
Posted: Wed Jan 05, 2022 5:30 pm
by Windcatcher530 Dan
Windy thanks for PM sorry but I haven't figured out how to respond back.im gonna try to find the original first if i can't I'll try what you suggested.Thanks
Re: Wooden Sucker rod end
Posted: Wed Jan 05, 2022 5:52 pm
by windybob
That's fine. no problem.