Page 2 of 2
Re: Aermotor M1 Grinder parts
Posted: Sun Jul 03, 2022 10:45 pm
by hwy8
Do you still have the slip clutch? Is it a regular pulley with a clutch built into it? I'm dreaming of making a line shaft set up so I'd better get started looking at some old millwright books just to become acquainted with the mechanisms and all of the parts.
Re: Aermotor M1 Grinder parts
Posted: Mon Jul 04, 2022 9:47 am
by Windcatcher530 Dan
When I sold the power mill all parts went with it. Here's what the slip or ratchet clutch and foot gear look like.
20220704_103833.jpg
20220704_103833.jpg
Re: Aermotor M1 Grinder parts
Posted: Mon Jul 04, 2022 9:52 am
by Windcatcher530 Dan
Re: Aermotor M1 Grinder parts
Posted: Mon Jul 04, 2022 11:19 am
by hwy8
I didn't have a clue that is what a "slip clutch" is....I was thinking it is a belt-pulley with a clutch to engage/disengage....
Re: Aermotor M1 Grinder parts
Posted: Mon Jul 04, 2022 12:49 pm
by Windcatcher530 Dan
Burt if you have any further questions you can give me a call at 518-948-3299 (Dan)