Vintage Windmill and Wind Generator Forum

Posted: **Sun Jun 02, 2024 12:01 pm**

Or if anyone has a complete unit and could trace the cast parts described , I'd certainly pay for your time and postage ........

Posted: **Sun Jun 23, 2024 3:31 pm**

Found One !! .......... Could still use a coupling half for 3/4" shaft

Posted: **Sun Jun 23, 2024 4:28 pm**

Talk about luck, you should play the lottery!!

Posted: **Sun Jun 23, 2024 4:56 pm**

Well , .... really wasn't much luck involved , it was locked in these , took a lot of cutting , welding , grinding and such to get it out !!

Posted: **Tue Jun 25, 2024 3:18 pm**

Now THAT"S my kind of engineer!

I've done stuff similar to that in the past, that should get me tossed in windmill jail....

Posted: **Wed Jun 26, 2024 11:09 am**

Thanks , I think ........ Probably has something to do with the color of things under my collar .........

Posted: **Sat Aug 10, 2024 4:02 pm**

Pretty much down to just needing the cast iron drive coupling half , for 3/4" shaft , seen here , lower left . Other two parts are about built .....

DSC_0905.JPG

Posted: **Sat Aug 24, 2024 3:52 pm**

can't wait to see the end result!

Posted: **Tue Aug 27, 2024 10:15 pm**

Pitman pretty much done , all but the babbit ......

DSC_0932.JPG

Posted: **Wed Aug 28, 2024 3:44 am**

Really nice job,evan has the oil cup !!!

Aermotor Power Mill "Pump Gear" parts