Page 2 of 2
Re: Challenge 27 wheel arms
Posted: Tue Apr 21, 2020 7:12 am
by martinmil
Hi i have been on this site way back in around 2000 ,this is the 3rd change i think.Any way i live in Minnesota and there is a fastenal store 20 miles away . what i need is 5 inner and outer rails and 3 wheel arms 8ft baker /monitor Thanks Windy Bob for your time
Re: Challenge 27 wheel arms
Posted: Tue Apr 21, 2020 7:46 am
by windybob
Okay. Did you get ahold of the Herrigs? Jud may be close to you. Other wise let me round up the parts and see what I can do. I have shipped lots of things Fastenal. They are reasonable on the rates, but might have to wait a while for delivery.
Re: Challenge 27 wheel arms
Posted: Tue Apr 21, 2020 11:12 am
by martinmil
Hi I think Jud is in southern mn im up north , So sounds good i can wait for the parts if you want to send them to me. thank WB
Re: Challenge 27 wheel arms
Posted: Tue Apr 21, 2020 4:53 pm
by windybob
I need to dig out a wheel I think is 5 section. No sails, they all broke off. LOL looks nice from what i see so far. Just need to un-bury it to make sure it's 5 section. Would be nice to have all of what you need from a single wheel
Re: Challenge 27 wheel arms
Posted: Wed Apr 22, 2020 10:49 am
by martinmil
Hi I hope that works out so you dont have to waste much time finding parts for me.When i was first no this site i think someone from Colorado ran it.Everyone help me with a lot of my windmill questions over the years Thanks
Re: Challenge 27 wheel arms
Posted: Wed Apr 22, 2020 3:47 pm
by windybob
Did'nt get a chance today. Will try tomorrow.
Re: Challenge 27 wheel arms
Posted: Fri Apr 24, 2020 9:15 am
by martinmil
Hi ,when ever you get time is ok Thanks Dale
Re: Challenge 27 wheel arms
Posted: Fri Apr 24, 2020 11:45 am
by martinmil
Hi Windy Bob can we put the parts on hold I may have found some here Thanks
Re: Challenge 27 wheel arms
Posted: Fri Apr 24, 2020 5:33 pm
by windybob
Sure. Not a problem.