Baker WB & three leg tower issue
Re: Baker WB & three leg tower issue
No Wayne, that's a figment of your imagination. All the trees and branches down here are a figment of mine. lol
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: Baker WB & three leg tower issue
Yeah Windy that's the problem with having so much time on my hands my imagination runs wild.
Re: Baker WB & three leg tower issue
Jim I have a three leg wb baker if you still need measurements I have been offline and just now seen your post
-
Jim Corcoran
- Posts: 311
- Joined: Fri Dec 21, 2018 7:32 am
- Location: Austin, Texas
Re: Baker WB & three leg tower issue
Steve,
Thanks for the offer. I have a solution. I have a design of a 1/2" thick plate that can be used as an adapter between the WB lower ball race (head plate) and the the tower plates for the Stover 3 leg tower. I just need to get the plate cut and figure out where to drill all the holes and I should be home free.
Thanks once again.
Jim
Thanks for the offer. I have a solution. I have a design of a 1/2" thick plate that can be used as an adapter between the WB lower ball race (head plate) and the the tower plates for the Stover 3 leg tower. I just need to get the plate cut and figure out where to drill all the holes and I should be home free.
Thanks once again.
Jim
" You need to get at least 30 miles out of Austin before you're firmly back in Texas."
Re: Baker WB & three leg tower issue
I had posted this adapter plate for thoughts at some point in the past. It went to a Stover best I can tell as it came with a Stover turn table and M or a S.
You do not have the required permissions to view the files attached to this post.
