Page 2 of 2
Re: Baker WB & three leg tower issue
Posted: Thu Oct 29, 2020 9:03 am
by windybob
No Wayne, that's a figment of your imagination. All the trees and branches down here are a figment of mine. lol
Re: Baker WB & three leg tower issue
Posted: Fri Oct 30, 2020 9:16 am
by Wayne
Yeah Windy that's the problem with having so much time on my hands my imagination runs wild.
Re: Baker WB & three leg tower issue
Posted: Fri Oct 30, 2020 7:53 pm
by Smax
Jim I have a three leg wb baker if you still need measurements I have been offline and just now seen your post
Re: Baker WB & three leg tower issue
Posted: Fri Oct 30, 2020 8:14 pm
by Jim Corcoran
Steve,
Thanks for the offer. I have a solution. I have a design of a 1/2" thick plate that can be used as an adapter between the WB lower ball race (head plate) and the the tower plates for the Stover 3 leg tower. I just need to get the plate cut and figure out where to drill all the holes and I should be home free.
Thanks once again.
Jim
Re: Baker WB & three leg tower issue
Posted: Fri Oct 30, 2020 8:26 pm
by CTXmiller
I had posted this adapter plate for thoughts at some point in the past. It went to a Stover best I can tell as it came with a Stover turn table and M or a S.