Page 3 of 4
Re: power windmill
Posted: Sun Nov 28, 2021 11:07 pm
by Mike Hage
20181018_160909.jpg
20191012_172210.jpg
Looks to me like 29 chev. I have an extra axle and drums. They are worn out but you might be able to use if you shim them up. Maybe ill see you in the spring.
Mike
Re: power windmill
Posted: Sun Nov 28, 2021 11:27 pm
by Mike Hage
Joe the more I look at that the more I think that someone just took some F & W parts from maybe a 10 footer and built their own power mill with a chevy 1 ton axle that was on the farm. I can't see Flint and Walling using a chev axle for a power mill and selling it. Looks like there are pieces welded to it. I have no idea what an F & W power mill looks like but I'm sure they would have had there own castings no?
Re: power windmill
Posted: Mon Nov 29, 2021 10:32 am
by joe herman
Thanks Mike,
Your picture looks like what I have.Would have to make a hub plate that would bolt to the drum
so that it would accept the wheel arms. I have seen a couple of Bell Morris vanes north west of
Calgary.This was maybe ten years ago and I was new to the windmill bug.
I do plan to visit you as soon as the snow melts. Need to pick up a pump and any spare dempster #14
parts you might have.
Joe
Re: power windmill
Posted: Mon Nov 29, 2021 8:00 pm
by Windcatcher530 Dan
Mike does the brake drum bolt to the hub.If so how many inches deep is just the hub?
Re: power windmill
Posted: Tue Nov 30, 2021 5:57 am
by Mike Hage
It's on a tapered shaft with a single keyway.and then one nut on the end of the axle holds it tight
Re: power windmill
Posted: Tue Nov 30, 2021 5:59 am
by Mike Hage
It's on a tapered shaft with a single keyway.and then one nut on the end of the axle holds it tight
Re: power windmill
Posted: Tue Nov 30, 2021 6:53 pm
by joe herman
Mike be sure to save the nut that holds the hub on the axle,For sure I will take it as what you show is pretty well bang on with mine. Did that shoe have asbestos brake lining?
Joe
Re: power windmill
Posted: Thu Dec 02, 2021 10:19 am
by joe herman
Mike does that rear end have an enclosed drive shaft like mine?
Joe
Re: power windmill
Posted: Thu Dec 02, 2021 8:27 pm
by Windcatcher530 Dan
Joe is the wheel put together and if so can you take a picture I want to see the distance between the arms where they bolted on to the hub
Re: power windmill
Posted: Fri Dec 03, 2021 11:35 am
by joe herman
No it is not.It needs a lot of work as some of the sections are bent out of round.I did not want to
do all the repair required until I am able to come up with the right hub and drum.
I plan to see Mike in the spring and pick up some parts he has for me.
I have two Flint and Walling hubs #1882 that measure 12 inches.I don`t know what size mill
they are from. The wheel spokes from the power mill don`t look like they will work on this hub
without some modification.