Wanna be

[mtblah]

Kenneth , teck F & W question , the main gear shaft sits in a wood bearing , which sits in the main case casting , but only sits on about 1/4 inch ledge on each end . seams it has lasted a 100 years like that but should there be support accross 100% of the wood bearing ?

[Wayne]

I'd think not. The shaft is really going to be supported on each end. I'd think the center would float. Remember they spent a lot of money engineering that assembly and I bet somebody asked that question and they decided not.

[Kenneth]

No. They are only supported on each end. Mine were the same way. I guess the type of wood, (Hard Maple), doesn't give much and is able to take it. If you replace them, your main shaft will sit a little higher. That's where those double nuts come in to play. To adjust the clearance.

[windybob]

Probably an oil reservoir to keep the bearing soaked. Thank me later.

[Windcatcher530 Dan]

I was thinking the same thing Bob !!

[mtblah]

Windy , now that you mention that fact , i think that my be the correct answer !! ,

[Wayne]

Yep!