Page 5 of 9
Re: Hello! And thanks in advance for the guidance
Posted: Sun Feb 13, 2022 12:44 pm
by Oldwindmill
Sails with edges like this are good to put in the air? I have approximately 7 sales with edges that are chipping off (some better/worse then this example).
Re: Hello! And thanks in advance for the guidance
Posted: Sun Feb 13, 2022 12:57 pm
by Windcatcher530 Dan
Okay i couldn't see they were that bad yes they should be replaced maybe you can find some good used ones to keep the patena
Re: Hello! And thanks in advance for the guidance
Posted: Sun Feb 13, 2022 5:17 pm
by windybob
I will see what I have tomorrow.
Re: Hello! And thanks in advance for the guidance
Posted: Sun Feb 13, 2022 5:53 pm
by Oldwindmill
windybob wrote: Sun Feb 13, 2022 5:17 pm
I will see what I have tomorrow.
Thank you very much!!!!
Re: Hello! And thanks in advance for the guidance
Posted: Tue Feb 15, 2022 7:38 am
by windybob
WIll try to get down there today. Been sick in bed most of the weekend. Sorry.
Re: Hello! And thanks in advance for the guidance
Posted: Tue Feb 15, 2022 8:04 am
by mtblah
Windy , most important is to take care of you ! Take care of your heart !
This other stuff can wait , we care about you .
Mike B
Re: Hello! And thanks in advance for the guidance
Posted: Tue Feb 15, 2022 8:25 am
by windybob
Thanks. I really need some fresh air though. ill be looking at winter from the warm side of the glass in a day or so, but fresh air now will be good.
Re: Hello! And thanks in advance for the guidance
Posted: Tue Feb 15, 2022 11:24 am
by windybob
I have a few of these, this is my best one. Still a bit worn on an angle, but much better than yours. Outside diameter is around 3 1/4". Shaft size is
1 1/8". Typical. I do have sails also. Just need to get them off the rails.
8ft woodmanse pinion.jpg
Re: Hello! And thanks in advance for the guidance
Posted: Tue Feb 15, 2022 3:45 pm
by Oldwindmill
windybob wrote: Tue Feb 15, 2022 11:24 am
I have a few of these, this is my best one. Still a bit worn on an angle, but much better than yours. Outside diameter is around 3 1/4". Shaft size is
1 1/8". Typical. I do have sails also. Just need to get them off the rails.
8ft woodmanse pinion.jpg
That’s awesome!! Im def interested in both the pinion (best one if your willing to part with it
. And 8 sails, if you have 8? You can message me with the specific details if you want!
Thank you very much!
Re: Hello! And thanks in advance for the guidance
Posted: Tue Feb 15, 2022 8:17 pm
by mtblah
Those of you that have the windmill calendar , look at March .
The caption under the photo says "yah , he's got it " It's amazing what a collection of parts & knowledge Windy has , and willing to share both .
Mike B