Page 1 of 1
8' aermotor v rod measurements
Posted: Tue Jan 12, 2021 1:59 pm
by Billt
Trying to get all my parts ready for spring to install my 21' tower and fan. Have a used mill and some of v rods are bent. What is a rough measurement of the wide end of the v rods. Not sure if the ones that aren't bent is right. Any help would be appreciated. Thanks Bill
Re: 8' aermotor v rod measurements
Posted: Tue Jan 12, 2021 2:33 pm
by IvanBlock
Bill that measurement is 38 1/2" but if you're within a couple of inches its good. They will flex enough to get them into the outer rim holes. I'm located just a little over a hundred miles southwest of you near Wausau. If you need any other info or Aermotor parts let me know. I've rebuilt 7 or 8 Aermotors every year (or more) since I retired 12 years ago, so do have some experience with them...
Re: 8' aermotor v rod measurements
Posted: Tue Jan 12, 2021 2:48 pm
by Billt
Thanks for the reply.. would like to talk to you as I will be needing some parts..feel free to call me. Bill
906-two 8 four- 944 eight