Vintage Windmill and Wind Generator Forum

Greetings all! It might not actually be the biggest, but it’s my story and I’m sticking to it! My name is Tyler. Located out in the mountains of far western Idaho. I picked up a mostly complete Aermotor E602 found lying in a field in Butte, Montana. Operation feels smooth and with little to no play. If I can track down some very hard to find parts then I’ll pay out a fortune to set up this beast on a well for stock water. Now my quest for unicorn parts begins!

Very nice good luck with your project

A 16 footer is not quite a 20 footer, but it'll do. lol I bet more parts are available than you may think. Welcome to the forum!

Hello Ron.....

By the way, how deep to the water in you area?

The competition for biggest in western ID already exists. I took this one up there in early 2019. It was about an hour north of Nampa in the mountains. E702 on custom customer provided wood tower


Ron Stauffer
Montrose CO

Tyler , nice project , Windy is right , lots of parts available for Aermotor ,

Ron , nice custom job you did in 2019 .

Mike B

Welcome Tyler! Look forward to seeing you get this mill up and flying. Post lots of pics. Don't hesitate to ask questions. That's what we're here for.

Tylder , send me your address please . I will share the new windmill calendar with you that has a 20 foot fan
you can PM at the top of this page .
Mike Blahnik
New Braunfels TX

I've driven through Western Idaho beautiful country.