Aermotor B602 restoration

Share and discuss your windmill related projects.
Post Reply
User avatar
windybob
Posts: 3503
Joined: Mon Jan 14, 2019 5:59 pm
Location: Ames Oklahoma

Re: Aermotor B602 restoration

Post by windybob »

The barrel is under a wooden floor or deck of sorts. The well pipe goes thru a hole in both, tight enough to keep dirt etc out. The well pipe has a flange of sorts around it, and the flange boles to the deck (floor). It extends up to a T with a pipe feeding the tank, and from the T goes up about a foot or two. The jet rod (sucker rod) Goes to the windmill pump pole, and goes down thru the pipe to the plunger inside the (cylinder) or PVC .I'll see if I can find a picture.
Call Dan Benjamin for parts. P M me for the phone number.
Windcatcher530 Dan
Posts: 1901
Joined: Sun Mar 28, 2021 4:06 pm
Location: Alcove N.Y.i buy and restore

Re: Aermotor B602 restoration

Post by Windcatcher530 Dan »

Gotcha thanks windy.
User avatar
windybob
Posts: 3503
Joined: Mon Jan 14, 2019 5:59 pm
Location: Ames Oklahoma

Re: Aermotor B602 restoration

Post by windybob »

Do you know how to take the plunger apart?
Call Dan Benjamin for parts. P M me for the phone number.
User avatar
windybob
Posts: 3503
Joined: Mon Jan 14, 2019 5:59 pm
Location: Ames Oklahoma

Re: Aermotor B602 restoration

Post by windybob »

I sent you a PM.
Call Dan Benjamin for parts. P M me for the phone number.
Windcatcher530 Dan
Posts: 1901
Joined: Sun Mar 28, 2021 4:06 pm
Location: Alcove N.Y.i buy and restore

Re: Aermotor B602 restoration

Post by Windcatcher530 Dan »

Got the pm thanks again
waterPumper
Posts: 60
Joined: Sat Mar 05, 2022 9:03 pm
Location: Tucson

Re: Aermotor B602 restoration

Post by waterPumper »

Any pictures and explanation of how to make a recirculating fountain into a stock tank would be greatly appreciated.
waterPumper
Posts: 60
Joined: Sat Mar 05, 2022 9:03 pm
Location: Tucson

Re: Aermotor B602 restoration

Post by waterPumper »

Windy, yes I was able to disassemble the plunger and am cleaning it up. Thanks
User avatar
windybob
Posts: 3503
Joined: Mon Jan 14, 2019 5:59 pm
Location: Ames Oklahoma

Re: Aermotor B602 restoration

Post by windybob »

That's good. Leathers also have a couple different inside hole sizes.
Call Dan Benjamin for parts. P M me for the phone number.
Wayne
Posts: 2115
Joined: Mon Dec 17, 2018 10:03 am
Location: Corsicana Tx.

Re: Aermotor B602 restoration

Post by Wayne »

The 2 inch PVC pipe I use to make cylinders is grey. I found out the hard way all 2 inch PVC pipe isn't the same inside Dia. Windy set me straight.
User avatar
windybob
Posts: 3503
Joined: Mon Jan 14, 2019 5:59 pm
Location: Ames Oklahoma

Re: Aermotor B602 restoration

Post by windybob »

The grey pvc may be conduit. Plumbing messes with my brain. Too many different sizes for any one measurement. I do know that tubing is measured on the outside, and pipe is measure on the inside.
Call Dan Benjamin for parts. P M me for the phone number.
Post Reply