I have a few questions about platforms for my "1/2 scale" windmill project. Given that a 2x6 is 5-1/2" wide, that puts the width about 16-1/2" which seems reasonable. The platform size is something that I would not want to scale down.
What is a comfortable elevation from the platform to the center of the wheel?
I was thinking of using 1-1/2" square tube x 11ga (~1/8"). It may be a bit expensive but it won't rot.
Platform size
Re: Platform size
Weldor by choice, engineer by necessity.
I believe in Gun Control.
Gun Control: The ability to hit what you are aiming at.
I believe in Gun Control.
Gun Control: The ability to hit what you are aiming at.
Re: Platform size
I’m not sure on that at all,,, but would suspect about 12” below the wheel radius. I can check a 27’ tower I have for an 8’ mill and let you know where is it in relation to the motor
Re: Platform size
Michael I think it would be a good idea to plant a nice crop of cotton at the base of the towers, but those stalls would be rough!!
Re: Platform size
I decided to build them as close to Aermotor original size as possible. Using 2X12’s for the large one and 5/4X6 for the oiler platform. Trying to keep it as close to authentic as I can.
You do not have the required permissions to view the files attached to this post.
Re: Platform size
Thanks!
-
- Posts: 1923
- Joined: Sun Mar 28, 2021 4:06 pm
- Location: Alcove N.Y.i buy and restore
Re: Platform size
Looks good Mark you have this windmillers approval *
Re: Platform size
Thanks a bunch Dan!
Re: Platform size
Michael , not only do you the talent to work with steel but now you show us you also work with wood just as beautifully .
Re: Platform size
Looks good.