Welcome Marcus

For New Members. Tell us about yourself.
Post Reply
mtblah
Posts: 1624
Joined: Thu Mar 26, 2020 12:09 pm
Location: new braunfels TX

Welcome Marcus

Post by mtblah »

Welcome aboard , Kerrvill is in the middle of windmill country , i suspect your surrounded by them .
Mike B
New Braunfels TX
mtblah
Posts: 1624
Joined: Thu Mar 26, 2020 12:09 pm
Location: new braunfels TX

Re: Welcome Marcus

Post by mtblah »

markus , my bad for improper spelling
Markus
Posts: 2
Joined: Thu Aug 18, 2022 5:20 am
Location: Kerrville, TX

Re: Welcome Marcus

Post by Markus »

Thanks Mike! Yes, there are quite a few in the Hill Country. I'll be putting on an old D702 back up in the air after a major overhaul.
Mark
mtblah
Posts: 1624
Joined: Thu Mar 26, 2020 12:09 pm
Location: new braunfels TX

Re: Welcome Marcus

Post by mtblah »

Markus , did you find everything , part , needed at the Aermotor store in San Angelo ?
CTXmiller
Posts: 933
Joined: Sat Dec 15, 2018 12:01 pm
Location: Waco, TX

Re: Welcome Marcus

Post by CTXmiller »

Welcome to the forum
Markus
Posts: 2
Joined: Thu Aug 18, 2022 5:20 am
Location: Kerrville, TX

Re: Welcome Marcus

Post by Markus »

I might have to do that Mike. So far I’m finding everything I need through networking.
mtblah
Posts: 1624
Joined: Thu Mar 26, 2020 12:09 pm
Location: new braunfels TX

Re: Welcome Marcus

Post by mtblah »

Yhe babbitt bearings will probably need to be replaced in your motor , this is a common wear point . These and every other part is available from Aermotor , but , some of us poured our own . What a learning experience . There is an interesting thread in the "lessons learned " section .
If you have any questions , dont hesitate to ask . Lots of VERY knowledagable windmills know all kinds of stuff .
Post Reply