Vintage Windmill and Wind Generator Forum

Welcome aboard , Kerrvill is in the middle of windmill country , i suspect your surrounded by them .
Mike B
New Braunfels TX

markus , my bad for improper spelling

Thanks Mike! Yes, there are quite a few in the Hill Country. I'll be putting on an old D702 back up in the air after a major overhaul.
Mark

Markus , did you find everything , part , needed at the Aermotor store in San Angelo ?

Welcome to the forum

I might have to do that Mike. So far I’m finding everything I need through networking.

Yhe babbitt bearings will probably need to be replaced in your motor , this is a common wear point . These and every other part is available from Aermotor , but , some of us poured our own . What a learning experience . There is an interesting thread in the "lessons learned " section .
If you have any questions , dont hesitate to ask . Lots of VERY knowledagable windmills know all kinds of stuff .