Page 1 of 1
Tower ID needed
Posted: Fri Feb 22, 2019 7:13 am
by PaulV
Dave Straub asked me to post this for him. Interesting method of attaching the cross braces. Any ideas?
1e6d024.jpg
Re: Tower ID needed
Posted: Sat Feb 23, 2019 6:04 am
by grezmonki
U.S. Wind Engine & Pump Co.
Re: Tower ID needed
Posted: Sat Feb 23, 2019 7:15 am
by Windmill Farmer
Monki, Do you know for sure? If your not sure I think it looks like Axtell. They had big towers and tank stands.
c
Re: Tower ID needed
Posted: Sat Feb 23, 2019 7:59 am
by wind fab
windmillers
Canadian made Toronto towers also look like that.
Paul in Canada
Re: Tower ID needed
Posted: Sat Feb 23, 2019 8:11 am
by windybob
I've seen one or two like that, but never knew what kind they were. Thanks.
Re: Tower ID needed
Posted: Sat Feb 23, 2019 9:58 am
by grezmonki
Windmill Farmer wrote: Sat Feb 23, 2019 7:15 am
Monki, Do you know for sure? If your not sure I think it looks like Axtell. They had big towers and tank stands.
c
No not for sure But Ive seen one pictured before and it was labeled as a U.S Windengine Part