Page 1 of 2
16ft Power Mill Article
Posted: Mon Jun 05, 2023 10:37 am
by JBarker
Re: 16ft Power Mill Article
Posted: Mon Jun 05, 2023 8:36 pm
by mtblah
Jerry , thank you for posting , very interesting .
Re: 16ft Power Mill Article
Posted: Mon Jun 05, 2023 8:58 pm
by Windcatcher530 Dan
Jerry is there a close photo of that mill especially the Hub? The photos I saw years ago are questionable, but that was when I was green.
Re: 16ft Power Mill Article
Posted: Mon Jun 05, 2023 10:22 pm
by Kansas Rust Buzzard
too bad they made the vid private, it was the best part!
Re: 16ft Power Mill Article
Posted: Mon Jun 05, 2023 10:23 pm
by Kevin
It is a Bell Hub Aermotor Power Mill beautifully restored.
I really enjoyed seeing and hearing it run when I was there is 2017.
Re: 16ft Power Mill Article
Posted: Tue Jun 06, 2023 5:38 am
by Windcatcher530 Dan
Okay thanks Kevin I didn't think it was an original 88 or 89.
Re: 16ft Power Mill Article
Posted: Tue Jun 06, 2023 7:01 am
by JBarker
Windcatcher530 Dan wrote: Mon Jun 05, 2023 8:58 pm
Jerry is there a close photo of that mill especially the Hub? The photos I saw years ago are questionable, but that was when I was green.
not that I could find
Re: 16ft Power Mill Article
Posted: Tue Jun 06, 2023 8:51 am
by Wayne
Did I miss something? Where is it located?
Re: 16ft Power Mill Article
Posted: Tue Jun 06, 2023 9:07 am
by Windcatcher530 Dan
Wayne I believe Pennsylvania.
Re: 16ft Power Mill Article
Posted: Tue Jun 06, 2023 12:20 pm
by mtblah
south easten side , near the Virginia border