Dempster 12 turntable

[mtblah]

would like a turntable assmbly for a DEMPSTER #12 , early model
Mike B
New Braunfels TX

[mtblah]

the official nomenclature of these parts are , ball race assembly & bed plate
could also use a wheel spider & brace spider

[Wayne]

Is Top casting and bed plate the same thing? I might have the parts will need to look. I take it's and 8 footer.

[mtblah]

correct , 8ft'
thanks

[windybob]

Dempster #12 has a few things in common between the 6 and 8 foot. Here they are.... Turntable upper and lower parts. 5/8 balls. Neckpipe. Pullout tube. Brake. (newer style). Pump rod. Tower top. Storm stay. Pullout swivel. Brake hubs are same, except larger hole for 1 1/8 shaft for 8 foot, instead of 15/16 shaft for 6 footers.

This does not include #12-A models. That's a whole different animal.

[mtblah]

Windy you said 1 1/8" , the main shaft size ? i measured 1.20 " close to 1 1/4 , did I measure wrong ?
I dont know how to use these fancey tools to measure things ,

[Wayne]

Mike I have a top casting the part that mounts on the angle iron legs plus the inside corners for mounting and a top bearing race don't have the bottom.

[windybob]

As far as I know its 1 1/8.