Mast Foos Co. Imperial

[windybob]

I believe they were a downgrade. At least grease cups contained grease, just go up there and screw them down a turn. Not so with zerks. Drag a grease gun up there every time, and hope they all take grease.

[PaulV]

All those grease zerks was that factory or someone's up grade.

Dunno. I don't recall ever being close enough to another Imperial to notice. Seems like close quarters for a lot of grease cups.

[PaulV]

Hey Paul, if you want to replace zerks with grease cups, holler at me. I have a box of mixed sizes.

Thanks Windy. Let me see what info I can find that shows the original configuration. I may wind up needing quite a few cups!

[PaulV]

Looks like I'm missing a few pullout components. I need to find detailed documentation or visuals of a compete mill.

[windybob]

I don't have anything on that mill. Do you have the 'green book' ? It can tell you where to find info...

[windybob]

If you don't , I can look it up for you.

[Windcatcher530 Dan]

Paul if you haven't already you might want to check with Judd herrig him and his brother have a lot of litterateur. Just a thought.

[PaulV]

If you don't , I can look it up for you.

I do have the green book. I'll have a look this evening.

[PaulV]

Paul if you haven't already you might want to check with Judd herrig him and his brother have a lot of litterateur. Just a thought.

Good advice, thanks Dan!

[Wayne]

I'm with you Paul about it being a tight fit for grease cups. I don't know whats worse taking grease up and having to fill cups or a grease gun and filling zerks. I bought me a fitting for my grease gun that clamps onto the zerks. I put it on the zerks and start pumping. It is WONDERFUL. It is well worth the money. I also have a clamp pump gun I can work with one hand.