Page 1 of 1
8 FT. SAMSON MODEL S TOWER GIRTS
Posted: Sun Aug 18, 2024 2:07 pm
by MIKES1958
HELLO
DOES ANYONE HAVE A SET OF 4 " GIRTS" [BRACES] FOR A SAMSON MODEL S UPPER TOWER LIKE THE ONES IN THE ATTACHED PICS ? THANK YOU , MIKE IN ARIZONA
Re: 8 FT. SAMSON MODEL S TOWER GIRTS
Posted: Wed Aug 21, 2024 4:20 pm
by windybob
Is that 4 inches center-to-center for the holes?
Re: 8 FT. SAMSON MODEL S TOWER GIRTS
Posted: Fri Oct 25, 2024 7:05 pm
by MIKES1958
hi bob
I PUT THE WORD " GIRTS " IN PARENTHESIS BECAUSE I WASN'T SURE I WAS USING THE RIGHT DESCRIPTION FOR THESE THINGS . MY UPPER TOWER WAS SO BENT UP I CAN'T TELL WHAT THE MEASUREMENT IS . IT COULD BE 6 INCHES FROM CENTER , BUT I'M NOT SURE AT THIS POINT . I DON'T KNOW WHY THE UPPER GIRTS ARE MISSING FOR MY UPPER TOWER . I DO THINK IT IS A SAMSON TOWER . IT HAD WOOD POLES BETWEEN THE UPPER & LOWER LEGS . IT WAS HALF WOOD & HALF ANGLE IRON . MIKE
Re: 8 FT. SAMSON MODEL S TOWER GIRTS
Posted: Fri Oct 25, 2024 8:07 pm
by Windcatcher530 Dan
I'll try to take measurements on my Stover tower tomorrow and some pics !!!
Re: 8 FT. SAMSON MODEL S TOWER GIRTS
Posted: Sat Oct 26, 2024 8:34 am
by Windcatcher530 Dan
Bolt hole center top gurt 5 3/4 , next gurt down 11 1/4 bolt holes. Gurts are 27inches apart.
20241026_092236.jpg
20241026_092236.jpg
Re: 8 FT. SAMSON MODEL S TOWER GIRTS
Posted: Fri Nov 15, 2024 9:24 am
by MIKES1958
HELLO
I JUST FOUND YOUR RESPONSE & PIC . I'M HAVING TROUBLE NAVIGATING THIS SITE . THANK YOU VERY MUCH FOR THE INFO . I WILL PROBABLY HAVE TO MAKE SOME UNLESS I FIND SOME FOR SALE . MIKE IN ARIZONA