Page 1 of 1
Bolt on Windmill weights
Posted: Fri Oct 04, 2024 7:22 am
by topcop491
There is
IMG_0198.png
an auction listing two bolt on windmill weights, but I’m not so sure. Does anyone know if these are for a windmill.
Re: Bolt on Windmill weights
Posted: Fri Oct 04, 2024 8:42 am
by Wayne
Don't look right to me, but there's a lot about windmills I don't know.
Re: Bolt on Windmill weights
Posted: Fri Oct 04, 2024 9:25 am
by windybob
Don't know. Looks perfect for trotline use though.
Re: Bolt on Windmill weights
Posted: Fri Oct 04, 2024 10:00 am
by Windcatcher530 Dan
Actually to me they look like the governor weight for a Dandy. At least the one on mine!!
Re: Bolt on Windmill weights
Posted: Fri Oct 04, 2024 12:05 pm
by windybob
I didn't get any with the 2 Dandys I worked over. Had to make them from cast iron pieces.
Re: Bolt on Windmill weights
Posted: Sat Oct 05, 2024 8:03 am
by hwy8
Over the years, I've had a couple of ancient power hacksaws that have used cast iron weights with mounting holes like those.
Burt
Re: Bolt on Windmill weights
Posted: Sat Oct 05, 2024 8:24 am
by Wayne
My governor weight for my Dandy fit on both sides of the angle iron. It was 2 piece.