Page 1 of 1
furl lever
Posted: Sat Oct 26, 2024 4:29 pm
by windyview
Hi wind mill pros!!
just attached a Aermotor furl lever to 4 leg tower.
no instructions how to attach cable to lever and adjust tension.
Any help much appreciated!!
Re: furl lever
Posted: Sat Oct 26, 2024 5:52 pm
by CTXmiller
You can slide the furl lever up or down the tower leg as needed.
furl lever -aermotor 602 - 4leg tower
Posted: Sun Oct 27, 2024 4:15 pm
by windyview
looking for instruction info on installing furl level --- how to connect cable and correct tension adjustment.
thanks for any advice
Re: furl lever -aermotor 602 - 4leg tower
Posted: Sun Oct 27, 2024 8:27 pm
by Ron Stauffer
From Baker's 702 book, 602 the same. Heed the placement on one of the legs opposite the furl lever but not on the tower ladder corner. Usually, vintage mills you will have the furl lever down against the mast base bolts.
furl install.jpg
Ron Stauffer
Montrose CO