Page 1 of 2
Hopefully an easy one
Posted: Thu Jan 23, 2025 9:48 am
by ksmokowski
I was hoping for an aeromotor, but I don't thing its one of those. But what is it and how hard are parts to find...
It does have the mandatory bullet holes.
472323968_966568908675498_1324464404811770646_n.jpg
Re: Hopefully an easy one
Posted: Thu Jan 23, 2025 11:28 am
by babraid
Neat! What an interesting hub - I can't wait for more knowledgeable Forum citizens to weigh in ..
Re: Hopefully an easy one
Posted: Thu Jan 23, 2025 12:16 pm
by CTXmiller
I’m thinking a Flint & Walling and possibly a model #24
Re: Hopefully an easy one
Posted: Thu Jan 23, 2025 12:19 pm
by Windcatcher530 Dan
Yep i agree a model 24 F and W.
Re: Hopefully an easy one
Posted: Thu Jan 23, 2025 1:06 pm
by windybob
I was also thinking F/W, but not sure of the model.
Re: Hopefully an easy one
Posted: Thu Jan 23, 2025 1:14 pm
by ksmokowski
Are parts available? I know for my Aeromotor I can get most anything.
Re: Hopefully an easy one
Posted: Thu Jan 23, 2025 1:49 pm
by windybob
Should be. Need to determine the size, most likely 8 ft. Dan B should be able to help. Do you have a way of getting it down?
Re: Hopefully an easy one
Posted: Thu Jan 23, 2025 5:44 pm
by ksmokowski
Not yet. I'm going to try and lower the tower this weekend.
I'm new to the forum, is there a "Read This First" that talks about how to lower the tower, how to....
Re: Hopefully an easy one
Posted: Thu Jan 23, 2025 7:14 pm
by CTXmiller
The equipment you have access to, tower height, and safety are the main factors.
Re: Hopefully an easy one
Posted: Thu Jan 23, 2025 7:18 pm
by Windcatcher530 Dan
My first question is did you already buy this Mill ?