Page 1 of 1
Dempsteretis
Posted: Sun Apr 20, 2025 5:40 pm
by mtblah
I guess i did not need the extension on the wrench to tighten the set screw
maybe i can cut a plate , drill 2 holes , thread a bolt in the center for the helmet and call it a day ???
Re: Dempsteretis
Posted: Sun Apr 20, 2025 6:15 pm
by CTXmiller
Mike,
Dempsters…
On the other end of the spectrum, I took a guide rod spacer off a challenge 27 yesterday evening and I don’t think I could break it. It was stuck good. Rosebud, ballping and even controlled use of a 3lb is what it took to come.
Re: Dempsteretis
Posted: Mon Apr 21, 2025 11:12 am
by windybob
Hold on Mike. I have an idea If you can'f find a replacement. Is that for your 10 footer?
Re: Dempsteretis
Posted: Mon Apr 21, 2025 9:11 pm
by mtblah
8 ft'r
Re: Dempsteretis
Posted: Mon Apr 21, 2025 9:16 pm
by mtblah
Windy , my thought is a steel bar an inch thick , drill 3/4 holes to hold the slide rods , set screww to hold in place , just thinking in a loud voice .
Re: Dempsteretis
Posted: Wed Apr 23, 2025 11:38 am
by windybob
I'm sending one to Mike.