Happy birthday
Posted: Sat May 04, 2019 3:18 pm
Happy birthday Peter!
Vintage Windmill and Wind Generator Forum
Est. Dec. 13, 2018
https://vintagewindmillforum.com/
Happy birthday
Page 1 of 1
Re: Happy birthday
Posted: Sat May 04, 2019 6:08 pm
Happy Birthday, youngster. lol
Re: Happy birthday
Posted: Sat May 04, 2019 7:47 pm
Happy Birthday Peter
Re: Happy birthday
Posted: Sat May 04, 2019 7:55 pm
Am sure he has those Aussie mills corrected for proper wheel rotation north of the equator but no pictures, eh? Happy Birthday!
Ron Stauffer
Montrose CO
Ron Stauffer
Montrose CO
Re: Happy birthday
Posted: Sat May 04, 2019 8:50 pm
Happy Birthday Peter 
Re: Happy birthday
Posted: Sun May 05, 2019 11:43 am
Thanks for the birthday wishes everyone!
Ron, I haven't done much with the Aussie mills yet. I did get a bunch of stuff ready to get galvanized, it will be next winters project. The picture of the Toronto wheel and tail is what I dragged home today
Peter
Ron, I haven't done much with the Aussie mills yet. I did get a bunch of stuff ready to get galvanized, it will be next winters project. The picture of the Toronto wheel and tail is what I dragged home today
Peter
Re: Happy birthday
Posted: Sun May 05, 2019 3:44 pm
So are going to fix today's treasure or sell pats/ You know what the next question is!
Ron
Ron
Re: Happy birthday
Posted: Mon May 06, 2019 11:34 am
Ron, if you want a Canadian Airmotor tail for a wall hanger this one is okay on one side, the other side has two rust patches from laying on the ground. I'm keeping the wheel I'm going to take it apart and re roll it.
Peter
Peter