Page 1 of 4
Custom Tail Art
Posted: Wed Dec 04, 2019 7:14 pm
by JBarker
Please share some of ur unique(custom) tail art here on this thread. Thanks
Jerry
PS-Kevin Moore this means you too, Ha!
Re: Custom Tail Art
Posted: Sun Dec 08, 2019 8:43 pm
by Les Jacox
The X-Rays we recently acquired had unusual tails. One had one side printed upside-down. Both mills had the tails mounted with the 'X-Ray' upside-down. Hopefully the pictures will tell the 'tail'.
DSCN1182a.jpg
DSCN1265a.jpg
DSCN1266a.jpg
Re: Custom Tail Art
Posted: Mon Dec 09, 2019 7:19 am
by windybob
How much for one mill?
Re: Custom Tail Art
Posted: Mon Dec 09, 2019 2:07 pm
by JK Windmills (RIP)
One I did for a golf course several years back...
Re: Custom Tail Art
Posted: Tue Dec 10, 2019 8:38 am
by Kevin
Jerry, you said unique so here it is.
Windmill_Tail_Art_Rose.jpg
Re: Custom Tail Art
Posted: Tue Dec 10, 2019 9:05 am
by Wayne
That's Cool! Was it low enough to the ground so you can appreaciate it?
Re: Custom Tail Art
Posted: Tue Dec 10, 2019 9:20 am
by Kevin
Yes, it is on a 21 foot tower and the art is very large so you can see it very well.
Re: Custom Tail Art
Posted: Tue Dec 10, 2019 10:49 am
by billcobb
I did this for my friend Bernie Beaton. RIP.
Re: Custom Tail Art
Posted: Tue Dec 10, 2019 11:04 am
by JBarker
Kevin wrote: Tue Dec 10, 2019 8:38 am
Jerry, you said unique so here it is.
Windmill_Tail_Art_Rose.jpg
awesome custom tail art everyone, keep them coming!
Re: Custom Tail Art
Posted: Tue Dec 10, 2019 11:05 am
by JBarker
Kevin wrote: Tue Dec 10, 2019 8:38 am
Jerry, you said unique so here it is.
Windmill_Tail_Art_Rose.jpg
Kevin,
Was that tail for your wife or girlfriend? Lol