Page 1 of 1
Boss Vaneless
Posted: Tue Mar 31, 2020 5:17 pm
by Kansas Rust Buzzard
Can anyone give me the arm length or section board width (one with slots) I just have iron but I can figure it out but having a measurement to start with would sure help me out. Thanks
Re: Boss Vaneless
Posted: Tue Mar 31, 2020 10:06 pm
by Terry
KRB
There is a Boss vainless at Shattuck inside the building. i do not have any measurements on it so I can not help you out.
Terry
Re: Boss Vaneless
Posted: Wed Apr 01, 2020 7:44 am
by Kansas Rust Buzzard
Thanks Terry, I may just have to wait for the windmill fair. I hope they delay it instead of cancelling it but I guess there is no telling. I have not been to Shattuck since they had a building with windmills, this is new to me.
Re: Boss Vaneless
Posted: Wed Apr 01, 2020 8:53 pm
by Terry
The new building has been up 5+ years. you need to get down there and look at it.
Terry