some assembly required
Posted: Sun Oct 04, 2020 8:57 am
after pouring the A702 babbitt bearings i immediately started assembly !
the case even got a little red paint.
i constructed a tripod to hold the motor upright for assmbly as the 3 legged tower will eventually hold the motor in the air.
now twisitng the wire for the upper section of the tower.
Thank you windybob, Paul V for the encouragement to under take this kind of project.
Mike Blahnik
New Braunfels TX
the case even got a little red paint.
i constructed a tripod to hold the motor upright for assmbly as the 3 legged tower will eventually hold the motor in the air.
now twisitng the wire for the upper section of the tower.
Thank you windybob, Paul V for the encouragement to under take this kind of project.
Mike Blahnik
New Braunfels TX