Page 1 of 1

Aermotor D602

Posted: Wed Oct 21, 2020 12:43 pm
by Topheavy64
I'm getting confused on which wheel spoke goes in which hole on the outside ring. Cant find any good clear pictures of a 602. Can anyone set me straight?

Re: Aermotor D602

Posted: Wed Oct 21, 2020 5:19 pm
by windybob
Same as a 702. Same pattern for all. Spokes should CROSS in the middle after coming out of the hub.

Re: Aermotor D602

Posted: Wed Oct 21, 2020 5:20 pm
by windybob
There are pictures somewhere on the site.....maybe check the library under Aermotor.

Re: Aermotor D602

Posted: Wed Oct 21, 2020 5:20 pm
by windybob
Oh,..Welcome to the site!

Re: Aermotor D602

Posted: Wed Oct 21, 2020 6:32 pm
by Mister Ed
Each outer band has 2 holes, one for a spoke from front of hub and one for spoke from rear. As you start putting on sections, keep overlapping them the same way all the way around the wheel. When you get to the last one, you will need to drop off one side of the first section to get the overlap right.

Hard to explain it that it will make sense. Bryon has a nice colored diagram, but I cannot find it.

Also make sure the angle of the threaded part of the V-spoke are angled to the outside when installing on the hub. That way the threads (tips of spokes) will be on the center line of the wheel.

Re: Aermotor D602

Posted: Wed Oct 21, 2020 9:26 pm
by Topheavy64
I have the spokes on the right way. I will start putting the sails on this weekend. I will start with a front spoke then a rear spoke all the way around. Thank you to all for the replys.

Re: Aermotor D602

Posted: Thu Oct 22, 2020 11:15 am
by Bryon
AermotorVspokeOverlapPattern.jpg
This is the same pattern for the screw-in spokes too.

Re: Aermotor D602

Posted: Thu Oct 22, 2020 8:46 pm
by Topheavy64
Byron - thank you very much. That is exactly what I needed.
Paul