Parts needed: Stover 10ft Model S
Posted: Tue Oct 27, 2020 8:19 am
For Sears and Roebuck Project lost cause. It's a pretty cool Timken bearing S model. I can buy the tapered roller bearings, fix the bent main shaft, make a new short shaft and bore that cast iron bearing bore. But 3 out of 4 gears are junk, and the connecting rods have been broken off and are missing.
Help me save this unit!
Help me save this unit!
TomsWaterPumper wrote: Tue Oct 27, 2020 8:05 am
10ft Stover Model S
crank gear:
(1) casting 6R10, 55 teeth, 11-1/4" OD (outside diameter), 1-3/8" ID (inside diameter) bore, 1" connecting rod hole, 1-3/8" wide
Both pinion gears:
(1)17 teeth, 3-3/4" OD, 1-1/4" ID w/keyway, 3-3/4" long
(1)17 teeth, 3-3/4" OD, 1-3/16" ID w/keyway, 3-1/8" long
Connecting Rods:
Mine are 80% missing, Crank gear end has 1" pin, sliding carriage end 1-1/2", 12" long c to c